Showing:

• 2-Way 2.4GHz 90dB Satellite-Splitter
• Power-Passive to One Port
• Insertion Loss 3.4-5.5dB max
• Port-Port Isolation 11-15dB min
• Input
• Return Loss 12-15dB min

• Highly Sensitive Meters with Built-In Buzzer -
• Durable ABS Plastic Housing -
• Built-in Buzzer with Pitched Tone for Alignment Reference -
• Front Panel Sensitivity Control -
• RF and DC Pass-Through - 75? 950-2050MHz Input -
• Sensitivity [email protected] - LNB Gain 3-Carrier C/N 15dB -
• Input Level -25 to -75dBm - LNB Gain 52-60dB -
• Power Requirements 13-18VDC -
• Requires 6dB attenuator for 60-65dB LNB gain

40-2400MHz 75 ohm High-Frequency F-Splitters -Suitable for Analog and Digital Satellite Applications -90dB min RFI Shielding - Epoxy-Sealed Back-Cover -High-Performance Printed-Board Circuitry -Improved Hum Modulation and Intermodulation -Yellow-Chromate Plating - Zinc-Alloy Cast Housing -3/8 in Precision Machined F-Connector Threads -Mounting Tabs with Screws - Cast-In Ground Block -DC Power Passing to One or All Ports for Remote LNB-Powering Applications and Powering Antenna Pre-Amplifier from

• 5-2050MHz Satellite Splitter - Combiners
• Separates or combines off air TV-antenna and satellite signals from or onto a single feed-line
• Zinc-Alloy Die-Cast Housing
• 40-2050MHz TV-Satellite Mini-Diplexer

Certain audio/video sources, such as a cable box or satellite receiver, may fail to work properly when their output is routed through a switcher or distribution amplifier, or even when connected directly to a TV. Often the problem may be related to direct current (DC) being present In the source's video output signal especially when color problems or picture stability problems occur. Our Model 1183 Active Video DC Blocker eliminates this problem by removing DC that may be present in the video ou

The SMR 1600 is a 2 input, 16 output rack mounted multiswitch that is powered from the headend satellite receivers connected to it. DC is presented to both inputs for LNB powering.

• Bandwidth (MHz): 950-2150
• Split/Tap Loss (dB): 4
• Isolation (dB): 20
• Switch Level (VDC): 11-14.5, 16-19
• Self Terminating, Max Power Passing to LNB 500 mA
• 19 x 1.75 x 5 in. 483 x 44 x 127 mm

5 input simple interface design provides 4 satellite polarity inputs plus 1 off air antenna and 16 outputs, for quick installation. Wide frequency range 40~2150MHz. Compatible with DIRECTV Phase III and other reception systems that utilize 22kHz tone switching.

• 5 input simple interface design provides 4 satellite polarity inputs plus 1 off air antenna and 16 outputs, for quick installation
• Wide frequency range 40~2150MHz
• Compatible with DIRECTV Phase III and other reception systems that utilize 22k

The FRM-Series is a non-penetrating roof mount for DBS, off air antenna, satellite internet systems and surveillance cameras. Using standard 8" x 8" x 16" cinderblocks as ballast the FRM-Series provides a good way to mount your equipment without damaging your roofing surface.

FRM-166 - 30" mast with 1.66" O.D.

These non-penetrating roof mounts are constructed of steel and use standard concrete blocks to anchor. For use with DBS, antenna and satellite internet systems.

FRM-125 - 60" mast with 1.25" O.D.